Quick Tips: Free 3D Printable Air-cooled Porsche Stuff
Do you know someone with a 3D printer? Do you like free air-cooled Porsche stuff? Read on…
Note: The following information is for educational use only. Before proceeding please read my disclaimer page.
Do you know someone with a 3D printer? Yes you probably do. Here are a couple free air-cooled Porsche 911 knickknacks you may like. They are free to download for personal use.
Porsche 914 911 Wiper Motor Arm Caps
These are a replacement for the OE caps that eventually disintegrate.
They fit over the hex nuts holding the wiper motor shafts to the cowl, under the wiper arm bases.
Replacement for Porsche P/N 90162892600. Should fit all 914s and 911s up to 1989. They probably also fit 912s. Maybe even the transaxle cars, not sure. At zero monies, the price is right to download them and give them a shot.
Use a UV and thermally stable material such as PETG. Enjoy.
Porsche 911 Front A-Arm Bushing Installation Tools
If you ever need to replace the bushings on your front A-arms you will find that you will likely need an installation tool to slide the bushings and bushing carriers back onto the arms themselves. This 2-piece tool lets you do both the front and rear bushings on the front suspension.
The larger tool sits inside the bore of the bushing carrier and lets you use a shop press, bar clamp, or a long piece of threaded rod and nuts and washers to press the bushings onto the arms.
The smaller tool has a tapered pilot which you will need to install the rear bushings on.
Print these out of anything, PLA, PETG, whatever. However print them at 100% infill for maximum strength. If you break one, just print another! Here is the link to download them.
As you know I design stuff all the time, so Ill share more free air-cooled Porsche 911 trinkets as I come up with them. Enjoy!
Leave a Reply
You must be logged in to post a comment.